Diagnosing an Excavator That Tracks to One Side
When a tracked excavator pulls to one side during straight travel, the slower track is a useful clue. The cause may lie in the hydraulic supply, a control valve, the travel motor, or the mechanical drive. Measuring hydraulic performance at the jobsite helps technicians decide where to investigate before removing components, which keeps machine downtime and parts costs under control.

Measure the Travel Circuit Before Removing Parts
The HIGHLAND MYHT portable hydraulic tester measures flow, pressure, and oil temperature. Technicians can use these readings to evaluate the travel circuit under the machine manufacturer’s specified test conditions. The tester model and connections should match the circuit’s expected flow and pressure, so the instrument itself never becomes the limiting factor in the test.
- Flow: confirms how much oil the circuit actually delivers under load.
- Pressure: shows whether the circuit reaches the working or relief pressure stated in the service manual.
- Oil temperature: keeps readings comparable, because viscosity changes shift both flow and pressure results.
Read Flow and Pressure Together
A pressure reading within specification can still leave a question unanswered: is the circuit delivering enough oil under load? Reading flow and pressure together helps answer that question. A circuit may hold nominal pressure while internal leakage reduces usable flow, and that combination is easy to miss when only one value is being monitored.
| Measurement Result | What It Tells the Technician | Suggested Next Step |
|---|---|---|
| Pressure in specification, flow low | Oil is bypassing internally instead of driving the travel motor | Check pump condition, valve seals and motor case drain |
| Pressure low, flow normal | Relief setting or valve adjustment is out of range | Verify the relief valve setting against the service manual |
| Flow and pressure both normal | The hydraulic supply is likely healthy | Inspect the travel motor and final drive on the slow side |
Narrowing the Search After the Test
If the hydraulic supply meets the manufacturer’s specifications, the technician can focus further checks on the affected side’s control valve, travel motor, or final drive, depending on the machine’s layout. Following this sequence avoids the common habit of opening the final drive first on a slow-track complaint, only to find the real fault in the hydraulic circuit.
- Record baseline flow, pressure and oil temperature on both travel circuits.
- Compare the weak side against the strong side and against the service manual.
- Trace any deviation to the supply, the control valve, the travel motor or the mechanical drive.
Verifying the Repair
After the repair, the service team can repeat the relevant measurements at a comparable oil temperature and check straight-line travel using the manufacturer’s procedure. The readings and the travel check give the workshop a record of what changed and whether the original symptom has been resolved, which is useful for warranty discussions and for catching a repeat fault before the customer does.
About the HIGHLAND MYHT Portable Hydraulic Tester
The HIGHLAND MYHT portable hydraulic tester is built for field service work: flow, pressure and oil temperature in one instrument that travels to the machine, instead of requiring the machine to travel to a test bench. For dealers, rental fleets and independent workshops, that means faster fault isolation on excavator travel complaints and better documented repair decisions.